Quantcast
Viewing all articles
Browse latest Browse all 5463

Hosts & Applications (Sequencers, DAWs, Audio Editors, etc.) • X, Y, and Z Joystick Protocol for CC Assignments

I was just wondering: is there a "protocol" (for lack of a better term) or "regular" set of continuous controller numbers that you use (or have discerned is normal) for assigning to the X, Y, and Z axes for your joystick use. So far, I've been using CC82, CC83, and CC84 for X, Y, and Z respectively, but I may have run into an issue connected with it, so I'm wondering if anyone could share any wisdom that they may have picked up along these lines.

Thanks in advance!

Statistics: Posted by dlandis — Sun Mar 24, 2024 9:06 pm — Replies 0 — Views 27



Viewing all articles
Browse latest Browse all 5463

Trending Articles